{"id":7070,"date":"2021-06-22T09:03:08","date_gmt":"2021-06-22T06:03:08","guid":{"rendered":"https:\/\/europan.ua\/?p=7070"},"modified":"2021-09-21T16:42:05","modified_gmt":"2021-09-21T13:42:05","slug":"prokladannja-kabeliv-v-kanalah","status":"publish","type":"post","link":"https:\/\/europan.ua\/en\/news\/prokladannja-kabeliv-v-kanalah\/","title":{"rendered":"Channel wiring"},"content":{"rendered":"
A cable channel is an extended closed non-passable structure, fully or partially buried in the ground, covering or floor, which allows laying cable lines, carrying out their repairs and inspections after removing the covering without carrying out earthworks.<\/p>\n
Laying in the cable channel provides a high protection of cable lines from mechanical damage and is used both outside and inside industrial premises.<\/p>\n The placement of cable channels is not allowed in areas where may be spilled the molten metal, high temperature liquids or substances that have a destructive effect on cable sheaths.<\/p>\n Channels are constructed from unified prefabricated reinforced concrete structures and, less often, from monolithic reinforced concrete or bricks. There are trough-type channels with ceilings (photo a) and channels made of prefabricated wall slabs with bases and ceilings (photo b).<\/p>\n There are channels of various widths and heights, rectangular or square cross-section. The depth of the channel should be no more than 1.2 m. And the width – at least 0.3 m for the channels up to 0.6 m deep, at least 0.45 m – for the channels with a depth of 0.6 m to 0.9 m, and not less than 0.6 m – for the channels with a depth of 0.9 m to 1.2 m.<\/p>\n On their top the channels have removable plates and they are protected with waterproofing. If the channels are located outdoors in unprotected areas, then they are made underground with the layer of ground as a covering with a thickness of at least 0.3 m on top of removable plates. In the case of intersection with motor roads, the channels are deepened by 0.7 m, and with railways – by 1 m. To prevent oil, ground, storm and process waters from entering the channels, their bottom is made at a slope of at least 0.5% towards the water collectors or storm sewers.<\/p>\n In cable channels built outdoors and located above the groundwater level, it is allowed to use an earthen bottom with drainage (filling with compacted gravel or sand 10-15 cm thick). And channels located in wet soils or below the groundwater level are made with waterproofing of the bottom and walls.<\/p>\n It is not necessary to cover cable channels with ground on the top of removable plates in fenced areas, accessible only to service personnel.<\/p>\n If the channels are located inside the premises, they are covered with removable plates made of non-combustible materials at floor level.<\/p>\n<\/a><\/p>\n
<\/a><\/p>\n